Balanced Flue
9
7.7 Log D ts onto the locating pin and rests on Log B, see
Diagram 16.
16
D
7.8 Sparingly spread an amount of the Embaglow bres provided
on the sections highlighted, see Diagram 17.
Take care not to use more than half a packet per application.
WARNING - DO NOT PLACE NEAR THE PILOT AREA.
17
8. Flame Failure Device
8.1 This is a safety feature incorporated on this appliance which
automatically switches off the gas supply if the pilot goes out
and fails to heat the thermocouple.
IF THIS OCCURS DO NOT ATTEMPT TO RELIGHT THE
APPLIANCE FOR 3 MINUTES.
9. Running In
9.1 During initial use of a new Gazco appliance a strong odour
will be encountered as various surface coatings become hot
for the rst time. Although these odours are harmless it is
recommended that the appliance is operated on maximum
for 4 to 8 hours in order to fully burn off these coatings. After
this period the odours should then disappear.
If the odours persists, please contact your installer for
advice.
9.2 During the rst few hours of burning there may be
discolouration of the ames. This will also disappear after a
short period of use.
User Instructions
10. Servicing
10.1 The appliance must be serviced every 12 months by a
qualied GasSafe Engineer. In all correspondence always
quote the Model number and the Serial number which may
be found on the Commissioning Checklist (Page 3).
11. Ventilation
11.1 This appliance requires no additional ventilation.
12. Installation Details
12.1 Your installer should have completed the commissioning
sheet at the front of this book. This records the essential
installation details of the appliance. In all correspondence
always quote the Model number and Serial number.
13. Hot Surfaces
13.1 Parts of this appliance become hot during normal use.
Regard all parts of the appliance as a ‘working surface’,
except for the access to the controls.
13.2 Provide a suitable re guard to protect young children
and the inrm.