Balanced Flue

6
TIMER MODE
Will turn the appliance on and off according to a pre-set
programme and automatically regulate the room temperature
during the two on periods.
5. Cleaning the Appliance
IMPORTANT: THE OUTER PANELLING OF THE
GAZCO VOGUE IS MADE FROM CAST IRON. USE
CAUTION WHEN INSTALLING, REMOVING AND
STORING AS THE COMPONENTS ARE HEAVY AND
SHOULD BE HANDLED CAREFULLY.
5.1 Make sure the re and surrounds are cool before cleaning.
Use:
– A dry cloth to clean the appliance casting.
– A damp cloth for the glass front.
Vogue Midi Models
5.2 Remove the plinth to access the controls by lifting the hooks
clear of the slots on the front of the appliance, see Diagram 4.
4
Vogue Midi Midline & Highline Models
5.3 Pull the lower door open from the right hand side to access
the controls, see Diagram 5.
5
Control
Valve
User Instructions
3. Turning OFF the Appliance
3.1 To turn the main burner off turn the left-hand knob until it
points to off ( ). Just the pilot remains lit.
3.2 Press in and turn the right-hand knob until it points to off
( ). The pilot goes out.
4. Upgrading the Appliance
4.1 The appliance is tted with a control valve that can easily be
upgraded to battery powered remote control.
There are two versions of this control which can be obtained
through your local Gazco retailer.
There is no requirement for this upgrade to be carried
out by an approved GasSafe engineer. However Gazco
recommend that this task is undertaken by a suitably
competent person.
4.2 This upgrade can be tted before or after installation but if
side clearances are limited then it will be easier to upgrade
the appliance before installation. Full instructions are
included with the kit.
If the appliance is left unattended for long periods of
time (e.g. vacation), it is recommended to place the
control valve in the Off or Pilot posiiton.
Take care when leaving the appliance unattended,
in exceptional circumstances sound waves from
sources other than the transmitter can cause
changes in the ame height adjustment.
DO NOT install two or more appliances using
upgradeable controls in the same room, interference
between the remote control frequencies can occur.
Standard Remote Control
(PART NUMBER 8455)
4.3 This remote control can control the gas appliance after
the pilot has been lit. It can turn the main burner on and
regulate it from low through to high and back again.
It can turn the main burner off leaving the pilot burning.
Thermostatic and Timer Remote Control
(PART NUMBER 8456)
4.4 This remote control can control the gas appliance after the
pilot has been lit.
MANUAL MODE
Can be used to turn the main burner on and manually
regulate it from low through to high and back again. It can
also be used to turn the main burner off leaving the pilot
burning.
AUTO MODE
Will automatically regulate the room to a pre-set
temperature.