Balanced Flue

28
Installation Instructions
Flue and Appliance Fixings
6.40 Pull appliance and ue assembly away from the hearth.
6.41 Drill 4 xing holes for the wall plate and insert wall plugs
supplied.
6.42 Put the horizontal ue onto the elbow and reposition the
appliance.
6.43 Check the ue runs smoothly through the wall.
6.44 Fix the wall plate to the wall using the 4 black screws
provided.
6.45 Drill through the xing tab of the wall plate using a 3.5mm
drill.
6.46 Secure with the screw provided.
6.47 Make good and weatherproof around the outside of the ue.
6c. Top Exit – Vertical Flue
6.48 Where a vertical only ue system has been purchased, refer
to Installation & Instructions, Site Requirements, Section 3D.
6.49 Pay careful attention to the following:
Terminal positions
Flue supports
Weatherproong
Fire precautions
6.50 Local and national codes of practice must be followed for all
the above.
6.51 A restrictor must be tted with vertical ues. See
Technical Specication on page 14 for restrictor sizes.
PLEASE NOTE: When installing the appliance in
conjunction with a vertical termination kit, there is a
unique kit for use with this appliance (Gazco Part No.
999-539). This kit differs in that it has restrictors with
sliding plates. Please ensure you have the correct kit
before proceeding with the installation.
6.52 It is important that the sliding restrictor assembly is used.
The restrictor assembly must be tted with the slide collars
uppermost and the top restrictor plate must be checked to
ensure it moves freely before the ue is tted.
Restrictor assembly
Slide collars
30
7. Gas Soundness Pressure Check
This is essential to expel any debris that may block the gas
controls.
7.1 Connect the gas to the 8mm elbow on the rear of the
appliance, see Diagram 31 & 32.
Vogue Midi & Midline
31
Vogue Midi, Midline & Highline T 3 Sided
32
7.2 Connect a suitable pressure gauge to the test point located
on the inlet tting and turn the gas supply on. Light the
appliance and check all gas joints for possible leaks. Turn
the appliance to maximum and check that the supply
pressure is as stated on the databadge. Turn the gas off and
replace the test point screw, turn the gas on and check the
test point for leaks.
8. Removing the Glass
8.1 Using a screwdriver remove the 4 screws securing the
window panel to the appliance, see Diagram 33 & 34.
Take care to support the glass when removing the screws.
Vogue Midi & Midline
33