Balanced Flue

25
Installation Instructions
4.6 Attach the decorative ue blanking plate support bracket to
the underside of the cast top using the screws provided.
Ensure the folded return is pressed against the cast top, see
Diagram 17.
17
4.7 Sit the decorative ue blanking plate in position, see
Diagram 18.
18
4.8 Replace the cast top. When tted properly the cast plate
should sit ush with the rear of the stove, see Diagram 19.
19
Vogue Midi Shown
5. Highline Freestanding Back Panel
(Optional)
The Vogue Highline can be supplied with an optional back
panel to allow the appliance to be installed in a manner
where it can be viewed from 360° without viewing the engine
components. Consult your Gazco retailer for details.
To t the back panel:
5.1 Loosen the two screws on the rear of the appliance, see
Diagram 20.
Do not remove completely.
20
5.2 Attach the supplied Gas pipe extension to the gas inlet of the
appliance.
This will run centrally down the back of the plinth and allow
the gas supply to be connected at oor level as required.
5.3 Hook the top of the back panel over the extended rear
screws, see Diagram 21.
21
5.4 Lower the panel and hook the lower brackets over the edge
of the appliance body mid way down, see Diagram 22.
22