Balanced Flue

24
Installation Instructions
NOTE: The top rear edge of the appliance must locate
between the back lip of the wall mounting bracket and
the raised supports, see Diagram 12.
Partially Engaged
Fully Engaged
Stove Body
Stove Body
Wall Mounting
Bracket
Wall Mounting
Bracket
Raised Support
Back Lip
12
3.28 Secure through the base of the bracket from underneath with
the 2 screws provided, see Diagram 11.
IMPORTANT: If it is required to access the rear
explosion relief for servicing the appliance must
rst be removed from the wall.
4. Top or Rear Exit
4.1 Before locating the appliance choose the correct ue outlet
position.
4.2 The appliance is supplied as a top exit conguration. To
switch outlets remove the cast top plate and decorative ue
collar, see Diagram 13.
13
Cast top
Decorative Flue Collar
4.3 The cast top plate lifts off to give access to the inner and
outer ue spigots, see Diagram 14.
14
4.4 Remove the 8 screws securing the inner & outer spigots, see
Diagram 15.
15
Outer
Spigot
Inner
Spigot
4.5 Swap the inner and outer ue spigots only with the inner
and outer blanking plates on the rear of the appliance, see
Diagram 16.
16
Outer
Blanking
Plate