Balanced Flue
23
Installation Instructions
3.17 Tighten the 4 loose screws (Diagram 7, Arrow B) and replace
the top 2 screws (Diagram 7, Arrow A).
WARNING: This appliance weighs 62kg.
The manufacturer has designed this appliance to
attach to a masonry wall and all xings supplied
reect this. If siting on a studwork wall, the xing
points must be through the timber stud and not
plasterboard. Use appropriate xings.
DO NOT attach solely to a plasterboard wall.
The xings supplied for the Wall Mounted Kit are
R-RBL Rawlbolts and should be tted in the method
described below.
2 3
1
Ensure a minimum substrate thickness of 100mm.
1. Drill a hole - Width: 14mm x Depth: 65mm.
Note: When xing into brickwork, mortar joints should
be avoided
Remove debris and thoroughly clean hole with brush
and pump
2. Remove pre-assembled bolt and washer. Insert shield
into hole and tap home with hammer until ush with
surface
3. Insert bolt with washer through xture into the shield
Tighten to 15Nm torque.
3.18 If installing on a studwork wall it is essential that the
batterns are located in the xing area for the wall
mounting bracket , see Diagram 9.
9
340
523
3.19 Position the wall mounting bracket in the required location.
3.20 Mark and drill the top left hand xing hole.
3.21 Secure with a screw, see Diagram 10, arrow A.
Do not tighten at this point.
10
B
A
Rear Exit
Spigot Hole
200mm ø
3.22 Level the wall mounting bracket and mark the remaining 3
holes, see Diagram 10, arrow B.
3.23 Remove the wall mounting bracket and drill the xing holes.
3.24 Rear Exit only: Cut a hole for the ue exit (see Section 6a.
Flue Assembly for details).
3.25 Replace the wall mounting bracket and secure with the
screws. Do not tighten at this point.
3.26 Level the wall mounting bracket, adjusting if necessary.
Tighten the 4 screws.
WARNING: This appliance is heavy and should be
handled with care. Two people must be used to lift
this appliance.
3.27 Hook the top of the bracket under the top of the carcass
at an angle and lower gently into position. Ensure that the
bracket is fully engaged, see Diagrams 11 & 12.
11
1
2
2 Screws
Bracket