Conventional Flue

1. General

1.1 All main components can be replaced without removing the

appliance from its installation.

IT IS ESSENTIAL THAT THE GAS SUPPLY TO THE

APPLIANCE IS TURNED OFF AT THE ISOLATION

DEVICE BEFORE PROCEEDING FURTHER.

1.2 Removal of Flue

If, for any reason, the ue has to be removed from the

appliance, the seal must be replaced in the inner spigot.

2. Removing the Glass Door

IMPORTANT: THE OUTER PANELLING OF THE

GAZCO LOFT IS MADE FROM CAST IRON. USE

CAUTION WHEN INSTALLING, REMOVING AND

STORING AS THE COMPONENTS ARE HEAVY

AND SHOULD BE HANDLED CAREFULLY.

2.1 Remove the plinth to access the controls:

1. Pull the lower section of the plinth forward to release from

the studs.

2. Lift the top section and tilt forward to clear the hooks

and slots on the front of the appliance, see Diagram 1.

2.2 Remove the 4 screws, see Diagram 2.

2.3 Lift the glass door slightly and angle the bottom away from

the appliance. Lower the glass door to disengage the top

hooks from the appliance, see Diagram 3.

NOTE: SUPPORT DOOR WHEN REMOVING.

2.4 Place carefully to one side.

2.5 The glass door must be retted to the appliance following

cleaning or servicing.

2.6 Angle the top of the glass door towards the appliance and

locate the top hooks into the bars of the appliance, see

Diagram 4.

2.7 Push the base of the glass door against the appliance and

lower.

Servicing Instructions - Replacing Parts