Conventional Flue

Installation Instructions

5. Removing the Glass Door

IMPORTANT: THE OUTER PANELLING OF THE

GAZCO LOFT IS MADE FROM CAST IRON. USE

CAUTION WHEN INSTALLING, REMOVING AND

STORING AS THE COMPONENTS ARE HEAVY

AND SHOULD BE HANDLED CAREFULLY.

5.1 Remove the plinth to access the controls:

1. Pull the lower section of the plinth forward to release from

the studs.

2. Lift the top section and tilt forward to clear the hooks

and slots on the front of the appliance, see Diagram 28.

The glass door will need to be removed to gain access to the

fuel effect.

5.2 Remove the 4 screws, see Diagram 29.

5.3 Lift the glass door slightly and angle the bottom away from

the appliance. Lower the glass door to disengage the top

hooks from the appliance, see Diagram 30.

NOTE: SUPPORT DOOR WHEN REMOVING.

6. Gas Soundness Pressure Check

This is essential to expel any debris that may block the gas

controls.

6.1 Connect the gas to the 8mm elbow on the rear of the

appliance, see Diagram 31.

6.2 Connect a suitable pressure gauge to the test point located

on the inlet tting and turn the gas supply on. Light the

appliance and check all gas joints for possible leaks. Turn

the appliance to maximum and check that the supply

pressure is as stated on the databadge. Turn the gas off and

replace the test point screw, turn the gas on and check the

test point for leaks.