Conventional Flue

Installation Instructions

3b.9 Pull the front of the side panels away from the appliance

and slide backwards to disengage the back tabs, see

Diagram 17.

3b.10 The anchor points for the sides and the front can now be

accessed, see Diagram 18.

3b.11 Position the appliance on the plinth and secure down

through the holes with the screws provided.

NOTE: If tting with a stone plinth it will be necessary to

place the screw threads in the xing holes in the stone

and apply felt pads to the underside before siting the

appliance.

3C. Base Section fixing

3c.1 To x to a hearth with a Base Section and leveling feet, rst

remove the mounting bracket from beneath the appliance.

3c.2 Remove the lower front panel to access the bolts that secure

the bracket, see Diagram 19. Note the bracket can be

accessed by tilting the appliance. Take care to support.

Remove the levelling feet - the bolts are used to secure the

appliance to the Base Section.

3c.3 Position the Base Section where required and mark the

holes to drill for the screws, see Diagram 20.

Slots for

screws

3c.4 Remove the Base Section and line the guide hole up with the

corresponding holes on the xing bracket.

Mark the xing bracket holes, see Diagram 21.

3c.5 Drill the xing bracket holes and insert the rawl plugs into the

guide holes.

3c.6 Reposition the Base Section and use the wood screws in the

xing kit supplied for hearth mounting installations to secure

in place.

3c.7 Position the appliance on the Base Section and secure

through the holes for the leveling feet with the screws

provided.

NOTE: If tting with a stone Base Section it will be

necessary to place the screw threads in the xing holes

in the stone and apply felt pads to the underside before

siting the appliance.