Conventional Flue

19
Installation Instructions
3a.4 Place in the desired position on the bench and mark the
holes to drill the bracket screws, see Diagram 13.
13
3a.5 Remove the bracket and drill the guide holes.
3a.6 Fix the bracket in place.
3a.7 Position the appliance on the bracket and secure down
through the holes with the xing previously removed, see
Diagram 13.
3B. Plinth fixing
3b.1 To x to a hearth with a plinth, rst remove the mounting
bracket from beneath the appliance.
3b.2 Remove the plinth to access the controls:
1. Pull the lower section of the plinth forward to release from
the studs.
2. Lift the top section and tilt forward to clear the hooks
and slots on the front of the appliance, see Diagram 14.
14
3b.3 Access the bolts that secure the bracket, see Diagram 15.
Note the bracket can be accessed by tilting the appliance.
Take care to support.
15
3b.4 Position the plinth on the hearth in the correct position and
mark the xing points, see Diagram 16.
16
3b.5 Remove the plinth and drill the xing holes.
3b.6 Position the plinth and place the mounting bracket in position
on top.
3b.7 Secure with the screws and rawl plugs provided.
3b.8 Remove the 2 side screws, see Diagram 17.
Screws
17