Conventional Flue

Installation Instructions

3. Fixing the Appliance to the floor

IMPORTANT: THE OUTER PANELLING OF THE

GAZCO LOFT IS MADE FROM CAST IRON. USE

CAUTION WHEN INSTALLING, REMOVING AND

STORING AS THE COMPONENTS ARE HEAVY

AND SHOULD BE HANDLED CAREFULLY.

3.1 To x the appliance via a Plinth or a Log Store it will

be necessary to gain access to the xing points on the

appliance:

3.2 Remove the plinth to access the controls:

1. Pull the lower section of the plinth forward to release from

the studs.

2. Lift the top section and tilt forward to clear the hooks

and slots on the front of the appliance, see Diagram 9.

3.3 Remove the 2 side screws, see Diagram 10.

Screws

3.4 Pull the front of the side panels away from the appliance

and slide backwards to disengage the back tabs, see

Diagram 10.

3A. Direct to Hearth

The appliance sits on a mounting bracket to secure it in

place to either the hearth or bench.

3a.1 To x to a hearth, rst remove the mounting bracket from

beneath the appliance.

3a.2 Remove the plinth to access the controls:

1. Pull the lower section of the plinth forward to release from

the studs.

2. Lift the top section and tilt forward to clear the hooks

and slots on the front of the appliance, see Diagram 11.

3a.3 Access the bolts that secure the bracket, see Diagram 12.

Note the bracket can be accessed by tilting the appliance.

Take care to support.