Conventional Flue

16
Installation Instructions
2. Top or Rear Exit
2.1 Before locating the appliance choose the correct ue outlet
position.
2.2 The appliance is supplied as a top exit conguration.
Rear Exit
2.3 To switch outlets remove the decorative ue collar, see
Diagram 1.
1
Decorative Flue Collar
Cast top
2.4 Remove the 2 screws from the back of the cast top plate,
see Diagram 1.
2.5 Remove the ue insert, cast top and screw, see Diagram 2.
2
Screw
2.6 Remove the ue collar adapter supports and the ue spigot
by removing the 4 screws, see Diagram 3.
3
Collar
Supports
1. Safety Precautions
1.1 For your own and other’s safety, you must install this
appliance according to local and national codes of practice.
Failure to install the appliance correctly could lead to
prosecution. Read these instructions before installing
and using this appliance.
1.2 These instructions must be left intact with the user.
1.3 Do not attempt to burn rubbish on this appliance.
1.4 Keep all plastic bags away from young children.
1.5 Do not place any object on or near to the appliance and
allow adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT
IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO
RELIGHT THE APPLIANCE.
IMPORTANT: REFER TO DATA BADGE AND
TECHNICAL SPECIFICATION AT THE FRONT OF
THE MANUAL TO ENSURE THE APPLIANCE IS
CORRECTLY ADJUSTED FOR THE GAS TYPE
AND CATEGORY APPLICABLE IN THE COUNTRY OF
USE.
FOR DETAILS OF CHANGING BETWEEN GAS
TYPES REFER TO SERVICING, SECTION 15,
REPLACING PARTS.
Unpacking
1.6 Remove the appliance from its packaging, and check that it
is complete and undamaged.
1.7 The cast plate is stored on top of the appliance. Remove and
store in a safe place.
Put the loose ceramic parts to one side so that they are not
damaged during installation.
Please note: As an optional extra Gazco can provide
a mains adapter to supply constant power to the
appliance control box instead of the battery pack.
If installing an appliance with the adapter make
provision for a mains power socket within 1.5m of the
control box and follow the instructions provided.