Balanced Flue

25
Installation Instructions
5.3 If installing on a studwork wall it is essential that
the battens are located in the xing area for the wall
mounting bracket, see Diagram 26.
26
5.4 Position the wall mounting bracket in the required location,
see Diagram 8, Page 18.
5.5 Mark and drill the top left hand xing hole.
5.6 Secure with a screw, see Diagram 27, arrow A.
Do not tighten at this point.
27
B
A
Rear Exit
Spigot Hole
200mm ø
Without a Top Box
5.7 Level the wall mounting bracket and mark the remaining 3
holes, see Diagram 27, arrow B.
5.8 Remove the wall mounting bracket and drill the xing holes.
5.9 Cut a hole for the ue exit (see Section 6a. Flue Assembly
for details).
5.10 Replace the wall mounting bracket and secure with the
screws. Do not tighten at this point.
5.11 Level the wall mounting bracket, adjusting if necessary.
Tighten the 4 screws.
WARNING: This appliance is heavy and should be
handled with care. Two people must be used to lift
this appliance.
5.12 Hook the top of the bracket under the top of the carcass
at an angle and lower gently into position. Ensure that the
bracket is fully engaged, see Diagram 28.
28
1
2
2 Screws
5.13 Secure through the base of the bracket from underneath with
the 2 screws provided, see Diagram 28.
5.14 Remove the leveling from the base and use them to secure
the base plate, see Diagram 29.
29
IMPORTANT: If it is required to access the rear
explosion relief for servicing the appliance must
rst be removed from the wall.