Balanced Flue

Installation Instructions

3c.4 Remove the Base Section and line the guide hole up with the

corresponding holes on the xing bracket.

Mark the xing bracket holes, see Diagram 19.

3c.5 Drill the xing bracket holes and insert the rawl plugs into the

guide holes.

3c.6 Reposition the Base Section and use the wood screws in the

xing kit supplied for hearth mounting installations to secure

in place.

3c.7 Position the appliance on the Base Section and secure

down through the holes for the leveling feet with the screws

provided.

NOTE: If tting with a stone Base Section it will be

necessary to place the screw threads in the xing holes

in the stone and apply felt pads to the underside before

siting the appliance.

4. Installation of the Appliance

IMPORTANT: THE OUTER PANELLING OF THE

GAZCO LOFT IS MADE FROM CAST IRON. USE

CAUTION WHEN INSTALLING, REMOVING AND

STORING AS THE COMPONENTS ARE HEAVY

AND SHOULD BE HANDLED CAREFULLY.

Without a Top Box

4.1 Ensure the ue is in the correct conguration, see Section 3.

Top Exit only

4.2 Ret the cast top or place the decorative stone top on the

appliance. The weight should hold the top in place.

Rear Exit only

4.3 Ret the cast top with the blanking plate attached, see

Section 2.

The spigot should be tted to the rear of the appliance.

Top Box Section

All Flue Installation types

Note: Installation is easier with the door removed - see

Section 8.

4.4 Remove the decorative ue collar, place carefully to one side

as this will need to be retted to the Top Extension Section.

4.5 Remove the 2 screws from the back of the top cast plate and

the screw under the grill, see Diagram 20.

4.6 Remove the ue insert and cast top plate.

4.7 Remove the Top Box Section xing bracket from the

underside of the Top Section Box, see Diagram 21.

4.8 Fix bracket in the groove on the top of the appliance and

secure with a screw, see Diagram 22.