Balanced Flue

20
Installation Instructions
2.7 Remove the screws securing the inner & outer spigots, see
Diagram 4.
4
Outer
Spigot
Inner
Spigot
2.8 Swap the inner and outer ue spigots only with the inner
and outer blanking plates on the rear of the appliance, see
Diagram 5.
5
Outer
Blanking
Plate
2.9 Attach the decorative ue blanking plate support bracket to
the underside of the cast top using the screws provided.
Ensure the folded return is pressed against the cast top, see
Diagram 6.
6
If installing a Top Extension Section, follow Section 4.
3. Fixing the Appliance to the Hearth
IMPORTANT: THE OUTER PANELLING OF THE
GAZCO LOFT IS MADE FROM CAST IRON. USE
CAUTION WHEN INSTALLING, REMOVING AND
STORING AS THE COMPONENTS ARE HEAVY
AND SHOULD BE HANDLED CAREFULLY.
For Wall Mounted Installations see Section 6.
3.1 To x the appliance via a Plinth or a Log Store it will be
necessary to gain access to the xing points on the appliance:
3.2 Remove the plinth to access the controls:
1. Pull the lower section of the plinth forward to release from
the studs.
2. Lift the top section and tilt forward to clear the hooks
and slots on the front of the appliance, see Diagram 7.
7
3.3 Remove the 2 side screws, see Diagram 8.
Screws
8
3.4 Pull the front of the side panels away from the appliance
and slide backwards to disengage the back tabs, see
Diagram 8.