Balanced Flue

27
Installation Instructions
5.25 Remove the leveling feet from the base and use them to
secure the base plate, see Diagram 34.
34
5.26 If using in conjunction with an Up and Out Flue kit t the ue
system now, see Section 6.
5.27 Remove the Top Box Section xing bracket from the
underside of the Top Section Box, see Diagram 35.
35
5.28 Fix bracket in the groove on the top of the appliance and
secure with a screw, see Diagram 36.
36
5.29 Remove the 6 screws at the rear of the Top Box Section to
remove the back panel, see Diagram 37.
37
5.30 Lift the Top Box Section onto the appliance and hook onto
the extension bracket, ensuring the sides are ush with the
back of the appliance.
5.31 Secure at the front of the re by with 2 screws up through the
xing bracket and into the Top Box Section.
There is no need to replace the back panel on the Top
Extension Section.
IMPORTANT: If it is required to access the rear
explosion relief for servicing the appliance must
rst be removed from the wall.
6. Flue Assembly
6.1 Refer to Site Requirements page 14 onward.
6a. Rear EXIT - Horizontal flue
Flue Length
6.2 Wall Mounted Models: Measure the total wall thickness and
add 25mm.
6.3 Other Models: Measure the total wall thickness and add
75mm.
The total ue length gives a minimum clearance of 50mm
between the rear of the appliance and the wall.
6.4 Insert the square cardboard sleeve into the ue to support
the inner tube.
6.5 Cut through the ue and sleeve, see Diagram 38.
200mm min
550mm max
38