Balanced Flue

Installation Instructions

3b.3 Access the bolts that secure the bracket, see Diagram 13.

Note the bracket can be accessed by tilting the appliance.

Take care to support.

3b.4 Position the plinth on the hearth in the correct position and

mark the xing points, see Diagram 14.

3b.5 Remove the plinth and drill the xing holes.

3b.6 Position the plinth and place the mounting bracket in position

on top.

3b.7 Secure with the screws and rawl plugs provided.

3b.8 Remove the 2 side screws, see Diagram 15.

Screws

3b.9 Pull the front of the side panels away from the appliance

and slide backwards to disengage the back tabs, see

Diagram 15.

3b.10 The anchor points for the sides and the front can now be

accessed, see Diagram 16.

3b.11 Position the appliance on the plinth and secure down

through the holes with the screws provided.

NOTE: If tting with a stone plinth it will be necessary to

place the screw threads in the xing holes in the stone

and apply felt pads to the underside before siting the

appliance.

3C. Base Section fixing

3c.1 To x to a hearth with a Base Section and leveling feet, rst

remove the mounting bracket from beneath the appliance.

3c.2 Remove the lower front panel to access the bolts that secure

the bracket, see Diagram 17. Note the bracket can be

accessed by tilting the appliance. Take care to support.

Remove the levelling feet - the bolts are used to secure the

appliance to the Base Section.

3c.3 Position the Base Section where required and mark the

holes to drill for the screws, see Diagram 18.

Slots for

screws