Beat Front Manual Installation User Instructions

Installation Instructions

2. Commissioning

If fitting the decorative frame and front ensure that the

commissioning tests are carried out BEFORE fitting the front.

3. Fitting the Frame

Slide Control Models Only

The foam seal must be fitted to the appliance prior to

attaching the Beat front.

3.1 On the right hand side of the appliance, place the foam seal

in the channel between the glass frame and the slide control

housing, see Diagram 1.

Step 1

Step 2

The foam seal must align with the right hand side of the

glass frame and 24mm below the top of the appliance ange.

3.2 NOTE: To fit the Beat Front first remove the 2 screws

securing the infill to the inside of the Front, see

Diagram 2.

Caution: When fitting the frame ensure that the

cutout fits around the slide mechanism, see

Diagram 3. Take care not to damage the slide

control handle during installation.

All Models

3.3 Locate top edge of frame onto tabs found at the top of

convector box and push down firmly to ensure correct fitting,

see Diagram 4.

3.4 Secure frame at base with fixing screws as shown to ensure

rigid fixing, see Diagram 5.