User Manual

5
Charging the Camera's built-in battery
1. Connect the supplied DC cord to the charging port of the
camera by removing the end plate cover on the camera.
Carefully slide up away from the camera plate.
2. Plug the cable USB port into any standard USB charging
adapter (Not included) with an output rating more than 1000mA
3. A red light indicator near the camera cover will illuminate while
charging.
4. Charge time takes 4 to 5 hours. Once fully charged the
indicator light will turn off.
Under normal use, the camera maintains a charge with exposure
to sunlight. A battery status indicator is provided on the monitor
when the camera is in use. If you're storing your vehicle in a
garage (or not exposing the camera to sunlight on a regular
basis) you may need to recharge it via the DC port.
NOTE:
* Prior to installation the camera must be fully charged.
USB port
End plate
DC port
Indicator light