Computer Drive User Manual
Table Of Contents
- Step 1: Installing the hardware and software
- Step 2: Configuring the USB adapter
- Step 3: Configuring the TCP/IP protocol
- Turning the wireless emitter off
- Where to go from here
- Windows XP
- Windows98SE, WindowsMe, and Windows2000
- Getting Help
- Safety, Regulatory, and Legal Information
3
Step 1: Installing the hardware and software
www.gateway.com
2 Connect the other end of the USB cable to a USB port
in your computer.
If this is the first time you have connected this
USB adapter to your computer, the Found New
Hardware Wizard opens. To complete the USB adapter
installation, go to “Installing the USB adapter driver”
on page 3.
Installing the USB adapter driver
Use the following instructions to install the USB adapter driver
for Windows XP.
8509438.book Page 3 Tuesday, August 12, 2003 1:23 PM