Computer Drive User Manual
Table Of Contents
- Step 1: Installing the hardware and software
- Step 2: Configuring the USB adapter
- Step 3: Configuring the TCP/IP protocol
- Turning the wireless emitter off
- Where to go from here
- Windows XP
- Windows98SE, WindowsMe, and Windows2000
- Getting Help
- Safety, Regulatory, and Legal Information
34
Chapter 2: Windows 98SE, Windows Me, and Windows 2000
www.gateway.com
4 Click Properties. The Internet Protocol (TCP/IP) Properties
dialog box opens.
5 Click Obtain an IP address automatically.
6 Click OK to close the Internet Protocol (TCP/IP)
Properties dialog box.
7 Click OK to close the Local Area Connection Properties
dialog box.
8 Click X to close the Network and Dial-up Connections
window.
9 Repeat this procedure for every computer on your
network.
10 After you set up the IP addresses on all your
computers, go to “Where to go from here” on page 36.
8509438.book Page 34 Tuesday, August 12, 2003 1:23 PM