Computer Drive User Manual
Table Of Contents
- Step 1: Installing the hardware and software
- Step 2: Configuring the USB adapter
- Step 3: Configuring the TCP/IP protocol
- Turning the wireless emitter off
- Where to go from here
- Windows XP
- Windows98SE, WindowsMe, and Windows2000
- Getting Help
- Safety, Regulatory, and Legal Information
29
Step 2: Configuring the USB adapter
www.gateway.com
6 Type a name for your workgroup in the Workgroup
box. Use a workgroup name of up to 15 characters
with no blank spaces. The workgroup name must be
the same for all computers in your network
workgroup, and the name must be different than any
computer name on your network.
7 Click OK to close the Identification Changes dialog box.
8 Click OK to close the System Identification dialog box.
9 After you name each computer and assign it to your
workgroup, go to “Step 3: Configuring the TCP/IP
protocol” on page 30.
8509438.book Page 29 Tuesday, August 12, 2003 1:23 PM