Computer Drive User Manual
Table Of Contents
- Step 1: Installing the hardware and software
- Step 2: Configuring the USB adapter
- Step 3: Configuring the TCP/IP protocol
- Turning the wireless emitter off
- Where to go from here
- Windows XP
- Windows98SE, WindowsMe, and Windows2000
- Getting Help
- Safety, Regulatory, and Legal Information
22
Chapter 2: Windows 98SE, Windows Me, and Windows 2000
www.gateway.com
Connecting the USB adapter
Use the following instructions to connect the USB adapter to
your computer.
To connect the USB adapter to your computer:
1 Connect the USB cord to the USB adapter.
2 Connect the other end of the USB cable to a USB port
in your computer.
3 If this is the first time you have connected this
USB adapter to your computer, the Add New
Hardware Wizard opens. To complete the USB adapter
installation, go to “Installing the USB adapter driver”
on page 23.
8509438.book Page 22 Tuesday, August 12, 2003 1:23 PM