Computer Drive User Manual
Table Of Contents
- Step 1: Installing the hardware and software
- Step 2: Configuring the USB adapter
- Step 3: Configuring the TCP/IP protocol
- Turning the wireless emitter off
- Where to go from here
- Windows XP
- Windows98SE, WindowsMe, and Windows2000
- Getting Help
- Safety, Regulatory, and Legal Information
15
Step 3: Configuring the TCP/IP protocol
www.gateway.com
6 Click the General tab.
7 Click Obtain an IP address automatically.
8 Click OK to close the Internet Protocol (TCP/IP)
Properties dialog box.
9 Click OK to close the Wireless Network Connection
Properties dialog box.
10 Click X to close the Network Connections window.
11 Repeat this procedure for every computer on your
network.
12 After you set up the IP addresses on all your
computers, go to “Where to go from here” on page 17.
8509438.book Page 15 Tuesday, August 12, 2003 1:23 PM