Quick Reference Guide

www.gateway.com
127
Replacing a CD, DVD, or Diskette Drive, or a
Memory Card Reader
To replace a CD, DVD, or diskette drive, or a memory card reader:
1 Remove the side panel by following the instructions in “Removing the side panel” on
page 121.
2 Remove the front bezel by following the instructions in “Removing the front bezel” on
page 122.
3 If you are replacing an existing drive, disconnect the cables from the drive, noting their
locations and orientation. You will reconnect the cables after you install the new
component. (CD/DVD drive shown.) If you are installing a new drive, go to Step 6.
4 Slide the drive release latch toward the back of the computer to the Unlock position, then
slide the drive or card reader forward and out of the drive bay.
5 Note any jumper settings on the old drive and set the jumper on the new drive to be the
same.
6 Slide the new drive or card reader into the drive bay, then slide the drive release latch
toward the front of the computer to the Lock position.
Tip
You need a Phillips screwdriver to add or replace a CD, DVD, or diskette drive, or a
memory card reader.
Important
The color and shape of your replacement component's front cover may vary
from your original component.