Quick Reference Guide

www.gateway.com
67
10 Remove the four screws that secure the system board to
the tray.
11 Align the new system board on the screw holes in the
tray, then secure it into the tray with the four screws.
12 If your replacement system board does not include a
processor, install the one you removed previously onto
the new system board by following the instructions in
“Replacing the heat sink and processor” on page 55.
13 Slide the power supply back into the case, then secure
it using the four screws you removed previously.
14 Reconnect the power cables to the system board.
15 Reinstall any memory modules and expansion cards you
removed previously.
16 Reinstall the drive cages and drives, and reconnect their
cables.
17 Replace the side panel by following the instructions in
“Opening and closing the case” on page 39.
Screw Screw
Screw Screw
8512730.book Page 67 Thursday, September 20, 2007 9:38 AM