Quick Reference Guide

CHAPTER4: Upgrading Your Computer
54
4 If you are replacing an expansion card, remove the old
card. You can slightly seesaw the card end-to-end to
loosen the card, but do not bend the card sideways.
5 If you are installing a new expansion card, remove the
EMI shield from the opening near the expansion slot.
6 Install the new card into the expansion slot. You can
slightly seesaw the card end-to-end to help insert the
card, but do not bend the card sideways.
7 Press the card retention lever back into place.
Caution
Do not touch the contacts on the bottom part of the expansion
card. Touching the contacts can cause electrostatic damage to the card.
8512730.book Page 54 Thursday, September 20, 2007 9:38 AM