Quick Reference Guide

CHAPTER 13: Adding and Replacing Components
130
6 Remove the hard drive.
7 Note any jumper settings on the old drive and set the jumper on the new drive to be the
same.
8 Slide the new drive into the drive bay, then slide the drive release latch back.
9 If you are adding a drive, connect the drive cables to the new drive.
- OR -
If you are replacing a drive, reconnect the drive cables using your notes from Step 4.
10 Replace the side panel by following the instructions in “Replacing the side panel” on
page 123.
11 Reconnect all external cables and the power cord.
12 Turn on your computer.
13 If Windows does not start, install Windows using the CD that came with your computer,
then install the drivers and applications using the CD provided. Follow any instructions that
may be printed on the Windows CD.
Jumper