Quick Reference Guide

CHAPTER 3: Maintenance Basics www.gateway.com
22
9 Note any jumper settings on the old drive and set the jumper on the new
drive to be the same.
10 Slide the new drive into the drive bay, then secure the drive to the bay
using the four screws you removed previously.
11 Slide the drive bay back into your computer, making sure that the tabs on
the bottom of the bay align with and slide into the slots on the bottom
of your computer.
12 Secure the drive bay to your computer using the screw you removed
previously.
13 Reconnect the drive cables using your notes from Step 3.
14 Replace the side pane by following the instructions in “Replacing the side
panel” on page 14.
15 Reconnect all external cables and the power cord.
16 Turn on your computer.
17 If Windows does not start, install Windows using the operating system CD
that came with your computer, then install the drivers and applications
using the drivers and applications disc that you created. Follow any
instructions that may be printed on the operating system CD.
Jumper
Hard drive bay
mounting slots