Quick Reference Guide

CHAPTER 3: Maintenance Basics www.gateway.com

4 Remove the two drive retention screws, then slide the drive forward and

out of the drive bay.

5 Note any jumper settings on the old drive and set the jumper on the new

drive to be the same.

6 Slide the new drive into the drive bay, line up the screw holes on the drive

bay with the screw holes on the drive, then replace the two drive retention

screws.

7 Reconnect the drive cables using your notes from Step 3.

8 Replace the front bezel by following the instructions in “Replacing the

front bezel” on page 14.

9 Replace the side panel by following the instructions in “Replacing the side

panel” on page 14.

Replacing the memory card reader

Tips & Tricks

You need a Phillips screwdriver to replace

the memory card reader.

To replace the memory card reader:

1 Remove the side panel by following the instructions in “Removing the side

panel” on page 12.

2 Remove the front bezel by following the instructions in “Removing the

front bezel” on page 13.

Drive retention screws