Quick Reference Guide

CHAPTER 3: Maintenance Basics www.gateway.com
20
6 Remove the two drive retention screws, then slide the drive forward and
out of the drive bay.
7 Slide the new drive into the drive bay, line up the screw holes on the drive
bay with the screw holes on the drive, then replace the two drive retention
screws.
8 Reconnect the drive cables using your notes from Step 4.
9 Replace the front bezel by following the instructions in “Replacing the
front bezel” on page 16.
10 Replace the side panel by following the instructions in “Replacing the side
panel” on page 16.
Replacing the memory card reader
Tips & Tricks
You need a Phillips screwdriver to replace
the memory card reader.
To replace the memory card reader:
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 14.
2 Remove the front bezel by following the instructions in “Removing the
front bezel” on page 15.
Important
The color and shape of your replacement
card reader’s front cover may vary from
your original card reader.
3 If you are installing a new card reader (not replacing an old one), remove
the two drive retention screws in the drive bay, then go to Step 6. For the
location of the screws, see the photo in Step 6.
Drive retention screws
Drive retention screws