Quick Reference Guide
Table Of Contents
- Contents
- About This Reference
- Checking Out Your Computer
- Setting Up and Getting Started
- Working safely and comfortably
- Preparing power connections
- Connecting to a broadband modem or network
- Connecting a dial-up modem
- Starting your computer
- Turning off your computer
- Restarting (rebooting) your computer
- Using the keyboard
- Using the mouse
- Adjusting the volume
- Configuring the audio jacks
- Installing a printer, scanner, or other device
- Setting up RAID
- Upgrading Your Computer
- Preventing static electricity discharge
- Opening the case
- Closing the case
- Adding or replacing memory
- Replacing the system battery
- Adding or replacing an optical disc drive
- Adding or replacing an optional diskette drive
- Adding or replacing the memory card reader
- Adding or replacing a harddrive
- Replacing the front fan
- Replacing the rear fan
- Replacing the power supply
- Replacing the heat sink and processor
- Replacing the I/O board
- Adding or replacing an expansion card
- Replacing the system board
- Maintaining Your Computer
- Troubleshooting
- Safety guidelines
- First steps
- Troubleshooting
- Add-in cards
- Audio
- CD or DVD drives
- DVD drives
- Ethernet
- File management
- Hard drive
- Internet
- Keyboard
- Media Center
- The Media Center video display looks bad on your TV
- You need to configure your Media Center computer to output to aTV
- You want to change display settings to get better TV or DVD image quality
- You want to know whether you can burn programs that were recorded with your Media Center computer...
- You want to know whether you can play recorded programs on other computers
- You want to know whether you can play recorded programs on your home DVD player
- You get a “Download Error” message when the Media Center tries to update the Program Guide:
- Memory
- Memory card reader
- Modem (cable or DSL)
- Modem (dial-up)
- Your modem does not dial or does not connect
- You cannot connect to the Internet
- Your 56K modem does not connect at 56K
- Your fax communications program only sends and receives faxes at 14,400bps when you have a 56K m...
- The modem is not recognized by your computer
- The modem is noisy when it dials and connects
- Monitor
- Mouse
- Networks
- Passwords
- Power
- Printer
- Sound
- Recovering your system
- Recovering pre-installed software and drivers
- Using Microsoft System Restore
- Recovering your system to its factory condition
- Recovering your system using the WindowsDVD
- Telephone support
- Legal Notices
- Index
CHAPTER 4: Upgrading Your Computer
62
4 Loosen the four screws that secure the heat sink to the
system board, then remove the heat sink. (The screws
cannot be completely removed.)
5 Release the processor by pushing down on the lever,
then lifting the lever completely up.
6 Remove the processor from the system board.
7 Install the new processor onto the system board making
sure that Pin 1 on the processor (indicated by the
silk-screened arrow on the corner of the processor)
aligns with Pin 1 on the processor socket (indicated by
the absence of a pin hole in the processor socket), then
return the lever to its locked position.
8 Place the heat sink on the system board, then tighten
the screws that secure it to the system board.
Caution
The heat sink has Thermal Interface Material (TIM) located on the
bottom of it. Use caution when you remove the old heat sink or unpack
the new heat sink so you do not damage the TIM.
Screws
8512066.book Page 62 Tuesday, January 16, 2007 11:02 AM