Owner's Manual

To enable a Remote Storage Server:

• On the computer that you want to configure as a Remote Storage Server, access the

command prompt and go to the directory where MSS40Srv.exe is located. To specify

the device to share and make it available, enter:

MSS40Srv -ISO (Filename).iso

• -iso [path to iso file]

When the executable prints an IP address (10.120.165.233) and Port number (5901), the

computer has been successfully configured as a Remote Storage Server.

To configure automatic Storage Server connections:

1 Access the Virtual Storage page in the BMC Web interface and enter the following:

• IP Address: The IP address of the Storage Server

• Port: The Port number of the Storage Server (port is always 5901)

• Share Index: Since only one device can be shared by running the Remote Storage

Server, the share index is always “0”.

2 Click the Valid box, then click Apply and Connect.

The Virtual Storage Status display is not always updated immediately. To verify that the

connection was successful, refresh the page.

From this point forward, all Remote KVMS Java Clients that are initiated from the BMC Web

interface will automatically receive a remote storage connection.