Quick Reference Guide
Table Of Contents
- Contents
- About This Reference
- Checking Out Your Computer
- Setting Up and Getting Started
- Working safely and comfortably
- Preparing power connections
- Connecting to a broadband modem or network
- Connecting a dial-up modem
- Starting your computer
- Turning off your computer
- Restarting (rebooting) your computer
- Using the keyboard
- Using the mouse
- Using optical drives
- Using the memory card reader
- Using the diskette drive
- Adjusting the volume
- Installing a printer, scanner, or other device
- Upgrading Your Computer
- Preventing static electricity discharge
- Opening and closing the case
- Replacing the optical disc drive
- Replacing the diskette drive
- Replacing the memory card reader
- Replacing the hard drive
- Installing memory
- Adding or replacing an expansion card
- Replacing the heat sink and processor
- Replacing the system battery
- Replacing the power supply
- Replacing the system board
- Maintaining Your Computer
- Troubleshooting
- Safety guidelines
- First steps
- Troubleshooting
- Add-in cards
- Audio
- CD or DVD drives
- Diskette drive
- The diskette drive is not recognized
- You cannot save a file to diskette or you see the message “disk is full or write-protected”
- You see an “Access Denied” or “Write protect” error message
- You see a “Disk is full” error message
- You see a “Non-system disk” or “Disk error” error message
- The diskette drive LED is lit continuously
- Display
- DVD drives
- Ethernet
- Expansion cards
- File management
- Floppy drive
- Hard drive
- Internet
- Keyboard
- Media Center
- Memory
- Memory card reader
- Modem (cable or DSL)
- Modem (dial-up)
- Your modem does not dial or does not connect
- You cannot connect to the Internet
- Your 56K modem does not connect at 56K
- Your fax communications program only sends and receives faxes at 14,400 bps when you have a 56K modem
- The modem is not recognized by your computer
- The modem is noisy when it dials and connects
- Monitor
- Mouse
- Networks
- Passwords
- Power
- Printer
- Sound
- Recovering your Windows Vista system
- Recovering pre-installed software and drivers
- Using Microsoft System Restore
- Recovering your system to its factory condition
- Recovering your system using the Windows DVD
- Recovering your Windows XP system
- Telephone support
- Legal Notices
- Index
CHAPTER 4: Upgrading Your Computer
68
8 Slide the system board tray toward the front of the case
for about one inch (2.5 cm), then remove the tray.
9 Remove the four screws that secure the system board
to the tray.
10 Align the new system board on the screw holes in the
tray, then secure it into the tray with the four screws.
11 If your replacement system board does not include a
processor remove the heat sink and processor from the
old system board by following the instructions in
“Replacing the heat sink and processor” on page 57,
then install them onto the new system board by
following the instructions in the same procedure.
Screw Screw
Screw Screw
8512138.book Page 68 Friday, March 16, 2007 4:33 PM