Owner's Manual

Using the Port Replicator
10
Canada
Unintentional emitter per ICES-003
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the radio interference regulations of Industry
Canada.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant
les limites applicables aux appareils numériques de Classe B prescrites dans le
règlement sur le brouillage radioélectrique édicté par Industrie Canada.
Canada Radio Frequency Interference
Requirements
This Class B digital apparatus complies with Canadian ICES-003, Issue 2, and
RSS-210, Issue 4 (Dec. 2000).
“To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding.
Equipment (or its transmit antenna) that is installed outdoors is subject to
licensing.”
Cet appareil numérique de la classe B est conforme à la norme NMB-003, No. 2, et
CNR-210, No. 4 (Dec. 2000).
“Pour empêcher que cet appareil cause du brouillage au service faisant l'objet
d'une licence, il doit être utilizé à l'intérieur et devrait être placé loin des fenêtres
afin de fournir un écran de blindage maximal. Si le matériel (ou son antenne
d'émission) est installé à l'extérieur, il doit faire l'objet d'une licence.”
European Union Notice
Products with the CE Marking comply with the EMC Directive (89/336/EEC) and
the Low Voltage Directive (73/23/EEC) issued by the Commission of the European
Community and if this product has telecommunication functionality, the R&TTE
Directive (1999/5/EC).
Compliance with these directives implies conformity to the following European
Norms (in parentheses are the equivalent international standards and
regulations):
■
EN55022 (CISPR 22) Electromagnetic Interference
■
EN55024 (IEC61000-4-2,3,4,5,6,8,11) Electromagnetic Immunity
■
EN61000-3-2 (IEC61000-3-2)-Power Line Harmonics
■
EN61000-3-3 (IEC61000-3-3)-Power Line Flicker
■
EN60950 (IEC60950) Product Safety
CE Caution: Due to the fact that the frequencies used by 802.11b wireless LAN
devices may not yet be harmonized in all countries, 802.11b products are
designed for use only in specific countries or regions, and are not allowed to be
operated in countries or regions other than those of designated use. As a user of
these products, you are responsible for ensuring that the products are used only
in the countries or regions for which they were intended and for verifying that
they are configured with the correct selection of frequency and channel for the
country or region of use. And deviation from permissible settings and restrictions
in the country or region of use could be an infringement of local law and may be
punished as such.