User Guide

www.gateway.com
67
Replacing the TPM module (select models)
Tools you need to complete this task:
v
Screws removed during this task:
To replace the TPM module:
1 Complete the steps in “Preparing the convertible notebook” on page 5.
2 Remove the bay module by following the instructions in “Replacing a bay module” on page 7.
3 If the convertible notebook has wireless networking built in, unplug the wireless antennas
by following the steps in “Replacing the IEEE 802.11 wireless card” on page16.
4 Remove the hard drive by following the instructions in “Replacing the hard drive” on page 21.
Important
If the TPM module is located in the wireless bay, use the procedure found in “Replacing
the TPM module (select models)” on page66 to replace the TPM module.
Flat-blade driver Scribe or non-marring tool- OR -
Phillips #0 screwdriver
5.0mm hex nutdriver
1 black 2.5*8.0 (Optional
bay module security
screw)
1 chrome 2.5*5.0 (Hard
drive)
2-4 black 2.5*5.0 (System
board)
2 black 2.0*2.5 (TPM
module)
2 black 2.5*8.0
(Keyboard)
4 or 6 black 2.5*8.0 (LCD
hinge to notebook)
14-16 black 2.5*8.0
(palm rest-bottom)
2 chrome 2.0*5.0
(palm rest-hard drive
bay)
3 chrome 2.0-0.4*2.0
(palm rest-modular
drive bay)
1 black 2.5*8.0 (palm
rest-top)