Quick Start Manual

82
Chapter 4: Installing Components
www.gateway.com
Replacing a hot-swap expansion card
Expansion cards installed in PCI card slots 5 through 8 can be replaced while
the server is on. If you are installing a card into the slot for the first time, see
“Installing an expansion card” on page 79 for instructions.
To replace a hot-swap expansion card:
1 Remove the top rear panel. For instructions, see “Removing the top rear
panel” on page 41.
2 Identify the failed expansion card. A green LED indicator above the card
means the card is functioning normally, and a yellow LED indicator means
the card has failed.
Caution When hot-swapping a card, the failed card must be
replaced by an identical card. If the card is a different type,
turn off the server and disconnect power before changing
cards.
Card operating
correctly
Card has failed