Quick Start Manual

52
Chapter 4: Installing Components
www.gateway.com
Replacing the power supply cage
Replacing a power supply cage may require the help of a qualified service
technician.
To replace the power supply cage:
1 Follow the instructions in “Preventing static electricity discharge” on
page 36. Make sure that you turn off the server, then unplug the power
cords and all other cables connected to the server.
2 Remove all of the power supplies. For instructions, see “Replacing a
hot-swap power supply” on page 47.
3 Remove the top rear panel, the top front panel, and the inside panel. For
instructions, see “Removing the top rear panel” on page 41, “Removing
the top front panel” on page 43, and “Removing the inside panel” on
page 45.
4 Remove the fans and fan cage. For instructions, see “Replacing a fan” on
page 58 and “Replacing the fan cage” on page 59.
5 Remove all full-length expansion cards. For instructions, see “Replacing a
hot-swap expansion card” on page 82 and “Replacing a standard expansion
card” on page 84.
6 Unplug all cables from the system board. For instructions, see “Replacing
the system board” on page 105.
7 Unplug all power cables from the CD drive, diskette drive, tape drive (if
any are installed) and the hot-swap hard drive cage.