Quick Start Manual

51
Installing power supply components
www.gateway.com
Adding a redundant power supply
To add a third (redundant) power supply:
1 Remove the front cover, if installed. For instructions, see “Using the front
cover” on page 39.
2 Remove the screw that secures the redundant slot’s cover to the server, then
remove the slot cover.
3 Insert the new power supply into the vacant slot, then press it all the way
in until it clicks into place.
4 If you have added a third power supply to the server for the first time,
you must run the FRU/SDR utility for the server to use it as a redundant
power supply. For instructions on running the FRU/SDR utility, see “Using
the FRU/SDR Load utility” on page 26.
Screw