Quick Start Manual

45
Opening the server case
www.gateway.com
Removing the inside panel
Remove the inside panel to access these components:
■ Memory board and memory modules
■ Processor board and processors
■ Standard PCI cards and card slots
■ System board
To remove the inside panel:
1 Follow the instructions in “Preventing static electricity discharge” on
page 36. Make sure that you turn off the server, then unplug the power
cords and all other cables connected to the server.
2 Remove the top rear panel. For instructions, see “Removing the top rear
panel” on page 41.
Warning For correct cooling, always install all panels before running
the server for an extended time. Operating the server for
longer than five minutes without the panels in place can
overheat and damage the server.
Warning This server has two power cords. To disconnect internal
AC power, you must unplug both power cords.