Quick Start Manual

43
Opening the server case
www.gateway.com
Removing the top front panel
Remove the top front panel to access these components:
■ Hot-swap hard drive cage
■ Hot-swap power supply cage
■ Tape drive
■ CD and diskette drives
■ Front panel board
To remove the top front panel:
1 Follow the instructions in “Preventing static electricity discharge” on
page 36. Make sure that you turn off the server, then unplug the power
cords and all other cables connected to the server.
2 Remove the front cover, if installed. For instructions, see “Using the front
cover” on page 39.
Warning For correct cooling, always install all panels before running
the server for an extended time. Operating the server for
longer than five minutes without the panels in place can
overheat and damage the server.
Warning This server has two power cords. To disconnect internal
AC power, you must unplug both power cords.