Quick Start Manual

138
Chapter 6: Troubleshooting
www.gateway.com
BIOS
The settings in the BIOS Setup utility are not retained
■ Replace the CMOS battery. For instructions, see “Replacing the CMOS
battery” on page 102.
CD drive
Your server does not recognize a CD or the CD drive
■ Restart your server, then open the BIOS Setup utility by pressing and
holding F2 while your server restarts. Make sure that the IDE controllers
are enabled. For more information, see “Using the BIOS Setup Utility” on
page 113.
■ Reinstall the device driver. For instructions, see Using Your Server Companion
CD.
■ Make sure that the drive is configured correctly by following the
instructions in the drive’s documentation.
Expansion ROM not
initialized
PCI Expansion ROM card not
initialized
Invalid System
Configuration Data
System configuration data destroyed
System Configuration
Data Read Error
System configuration data read error
Resource Conflict PCI card resource is not mapped
correctly
System Configuration
Data Write error
System configuration data write error
Warning: IRQ not
configured
PCI interrupt is not configured
correctly
8503: Incorrect memory
speed in location: XX,
XX, …
Non-PC200 DIMMs have been
installed in slots XX, XX, …
Code Error message Failure description