Quick Start Manual

96
Chapter 4: Installing Components
www.gateway.com
Installing a processor
The server is compatible with Intel
®
Xeon™ MP processors. The server
automatically detects the processors each time you turn on the server.
Whenever you install new processors, you should first install the most current
version of the BIOS. For instructions, see “Updating the BIOS” on page 115.
Before you begin
Removing a heat sink clip requires the use of the extraction tool shown below.
If you do not have the tool, you can purchase one from Gateway.
Important You must have a processor in socket 1, or your server will
not start.
If you install multiple processors onto the system board,
the processors must be the same speeds, revision, core
voltage, and bus speed.
If you are upgrading your server from one processor to
multiple processors, you may need to reconfigure your
operating system so it can recognize the additional
processor. For instructions, see your operating system’s
documentation.
Warning Processors and heat sinks may be hot if the computer has
been running. Before replacing a processor or heat sink,
allow them to cool for several minutes.
A heat sink must be installed on the processor. Installing
a processor without a heat sink could damage the
processor.