Installation Instructions

1. Features:
Installation instructions for Remote Control
1. The radio frequency handheld remote is battery operated (one PCS CR2025 battery included). This RF Remote control
long distance, mini size, wire connection is simple and very easy to use.
2. Remote Controller
Functions Of Each Button:
OFF
ON
RED
GREEN
BLUE
PINK
YELLOW
CYAN
WHITE
MULTIPLE
COLOR
Click the sync gradient under a single color+click the 8-color sync light change cycle
Synchronous jump under a single color + press 8 colors synchronous jump cycle
A single lamp bead flashes randomly under a single color + press 8 colors a single
lamp bead randomly flashes cycle
White light flashes chaotically when a single color is fully bright + press 8 colors
chaotically white light Flash cycle
A single lamp bead degenerates when a single color is fully lit + press again 8 colors
are fully lit Place a single lamp bead degeneration
8 color light change + 8 color jump change + 8 color single lamp bead flashing
randomly + 8 color full white light flashing randomly + 8 colors full bright single
lamp bead degeneration
3. FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital, pursuant to Part 15 or the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may casue harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If the
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--- Reorient or relocate the receiving antenna.
--- Increase the separation between the equipment and receiver.
--- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--- Consult the dealer or an experienced radio/ TV technician for help.