User's Manual Part 2

Installation Photographs
G
ATEKEEPER SYSTEMS INC.
2007
CART CONTAINMENT MANUAL
Page 48
9. Slide the heat shrink tubing back over the joint
so that the tubing extends about an inch past
the cut insulation on each end.
10. Use the torch to shrink the tubing tightly
around the joint.
Splice before heating the shrink tube
Sealing the Saw Cuts
Before sealing, mix the cold-pour asphalt sealant thoroughly,
using a drill and mixing wand
Use the SealMaster Cold-Pour Pot to apply the
sealer in an even manner.