User's Manual Part 1b

Installation
G
ATEKEEPER SYSTEMS INC.
2007
CART CONTAINMENT MANUAL
Page 29
Connecting Electrical Power to the CentralTransmitter
The CentralTransmitter may be powered using the power cord included, or by hard wiring the unit to an available
circuit. The circuit for the power outlet must be equipped with a 15 Amp circuit breaker. The Transmitter does not
require a designated circuit, but the circuit must have 24-hour power supply available. The circuit must be a non-
switched circuit. Use the voltage selector to set the proper voltage. Do not turn on any power to the transmitter
until instructed to do so in this manual.
The incoming power is terminated at TB1 AC. Terminate one wire to each of the Line Terminals. The ground wire
should to be green and yellow striped and should be connected to the ground screw located on the backboard
before getting connected to the ground connector of the power terminal. Do NOT power up yet!
Connecting the Central Transmitter power cable
NOTE: The CentralTransmitter should be connected to an Uninterruptible Power Supply (UPS) or hard wired to a
24-hour power source. Extension cords are NOT to be used. All connections must be in compliance with local
building codes.