User's Manual Part 1b

Installation
G
ATEKEEPER SYSTEMS INC.
2007
CART CONTAINMENT MANUAL
Page 31
Connecting the Alarm Relays
The CentralTransmitter Alert Relays provide the capability of forwarding CT status alerts to an existing store
monitoring or security system. There are two alert relay circuits built in to the GS
2
board:
• Power Alert Relay – outputs a signal from the Power Alert Relay connectors in the event of a power
outage to the CT.
• Antenna Alert Relay – outputs a signal from the Antenna Alert Relay connectors if the
CentralTransmitter stops receiving the terminating signal from the Perimeter Antenna.
To enable these alert relay features, the store’s Alarm Service Provider should connect the leads from the
appropriate store system to the Power Alert Relay connectors and/or the Antenna Alert Relay connectors, as
shown on the circuit board diagram, 27.
Information Tracker
Upon completion of the Central Transmitter installation,
make a note to indicate the Date, Line Resistance (from
your ohm meter), Locking Range, and technician Name in
the Central Transmitter Information Tracker. This should
be checked and updated on each successive service visit
to the store.
Information tracker with initial entry and two
subsequent service entries.