User's Manual

– 5 –
CHANGING RETRIEVALKEY BATTERY
Retrieval Key batteries will need to be replaced from time to time during the life
of the system. If you are having difficulty unlocking or locking the Gatekeeper
wheel you may need to replace the battery. In order to replace your Retrieval
Key batteries, perform the following steps. You will need a replacement CR123A
3V lithium battery. These are standard lithium batteries like the kind used in most
digital cameras. You will also need a coin in order to open the battery cover (a
quarter works best).
STEPS
1. Turn the Retrieval Key over so you are looking at the side opposite the front
panel. You will see a circular cover with a slot. Place the Retrieval Key on a
flat surface.
2. Insert your coin into the slot and turn counterclockwise until the battery cover
pops up.
3. Remove the battery cover and set aside.
4. Inside the Retrieval Key, you will see a nylon strap holding the battery in place.
Pull up on the nylon strap until the battery pops out.
5. Insert the new battery so it lies on top of the nylon strap (this will ensure easy
removal the next time you need to change the battery).
Make sure to align the “+” and “—” connectors on the battery with the “+” and
“—” indicators inside the Retrieval Key. Insert the “—” end first and then push
down on the battery until it snaps into place.
6. Once the new battery is in place, fold the remaining end of the nylon strap
back over the battery.
7. Take the battery cover and place it back on the Retrieval Key, making sure to
line up the notches on the battery cover with the notches on the Retrieval Key
opening. Push down on the battery cover until it is level with the surface of
the Retrieval Key. Turn the battery cover clockwise.
8. Insert your coin into the slot and turn clockwise until the battery cover clicks
into place.