User's Manual
GKS RECEIVER INSTALLATION FOR CARTMANAGER
Remove the main leads to battery positive, negative and negative
from the first battery before you start working for this installation.
Removing the old receiver
1. Remove the top cover retaining
screws at the top of the front control
column cover and two bellow the
Emergency stop button. Care fully lift
the top cover a little being careful not
to pull wires inside that are attached
to this part
2. Remove the front cover by sliding it
upward about 1-1/4” and then pulling
forward away from the neck.
3. Open the receiver box and remove all
the wires connected to the PC board
assembly.
4. Disconnect the round Harness
connector behind the electric panel in
the base unit to avoid damange to the
wiring harness when the neck is
removed.
5. Remove the two” retention bolts on
the back of the control column using
9/16” wrench.
6. Remove the two retaining bolts using
¾” (19mm) socket wrench at the
bottom-front of the column.
Caution: At this point the Neck will
come loose support it firmly and pay
extra attention to the wiring harness.
7. remove screws holding the the
Receiver box and take it out by sliding
it down thru the neck area
.
8.
If the antenna hole is smaller then
7/16” enlarge the hole using a 7/16”
drill(11 mm) for the thicker grommet
for the antenna, Install the grommet.
9. Insert and tighten the Antenna and
antenna cable as shown in the
picture.
10. Antenna ( P/N E7007)
11. Use antenna cable (P/N E7003)