Instructions / Assembly

PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Mallet Hammer
INSTALLATION INSTRUCTIONS
1. Hold the showerbasket up against desired position on wall,
and use a pencil to mark positioning of the screw holes (Fig. 1)
Use a measuring tape and a level for accuracy.
2. Drill 5/16 in. pilot holes into the wall where the tile anchors (E)
will be inserted (Fig. 2)
3. Place the tiles anchors over the holes (Fig. 2);
4. Tap flush the tile anchors (E) with the wall using a Mallet hammer.
5. Position the showerbasket over the tile anchors, place the threaded
rings (F) over the showerbasket holes, then insert the mounting screws (G)
through the threaded rings and tile anchors, and tighten firmly with Philips
head screwdriver. (Fig. 3)
6. Place one rubber ring (H) inside each cap (I) and secure
the caps on the mounting screws (G), one after another. (Fig. 4)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when
cleaning and never use any cleaning solvents.
• Philips head screwdriver
• Tape measure
1
• Level
• Safety glasses
Fig. 1
Fig. 2
Fig. 3
Top View
a.
b.
GENERAL INSTALLATION INSTRUCTION
SHOWERBASKETS #1497 and #1514
Top View
C
E
G
B
A
C
E
F
C
Fig. 4
Top View
C
E
G
H
I
I
H